HOW TO REMOVE THE REGISTRATION INFORMATION FROM STACKER 2.00

This will work on the stacker.com file dated 10-23-91 and is 40667 bytes long.
It may or may not work on other versions. You may adapt it and try it on 
other versions of the stacker.com file (see DISCUSSION for info). 

1) Use Norton Utility or a similar hex/text editor and go to file offset
   99C7 hex.
        It should be: 32 24 46 E2 F9 0A E4 C3
        Change to   : B4 00

2)  Go to file offset 3CF4 hex
        It should be: A5 98 9A 9C A6 A7 ..........ETC.
        Change to   : 53 53 53 53 53 53 ...........

    The number of "53"'s you add here is important.  18+(total # characters in 
    the encoded name).  For example if the registrants name is
    Gomer Q. Pyle you should add 18+13=31 "53"'s at this location.  Adding
    more may overwrite code and adding less will not completely erase the 
    name. If you are not sure, add less, check the results, then adjust.


           DISCUSSION OF ABOVE FOR C AND ASSEMBLY LANGUAGE PROGRAMMERS

Stepping through the COM file and changing the call (CALL 4A2E) to display the
registration information does not work.  Depending on how you do it (with NOP
versus call redirection) you will get no effect or a file checkum error on
execution.  What happened to me (not necessarily all the time I tried it)
was that the com file rewrote my NOP's back to CALL 4A2E when stacker was run.  
No, I didn't screw up the write and Yes, I'm sure it was the same stacker.com
that I just modified.  If you trace through you will discover that: 

        1) File checkum=true involves having 00h in AH at the end of 
           decoding. Inserting B4 00 (translates to MOV AH,00) at offset 99C7
           gets rid of that problem.
        
        2) The name (as well as the rest of the program) is encoded by adding  
           CDh to each byte stored past the decode call (I forget what the
           CALL is, sorry).  Therefore a space (20h) is encoded as 53h if you
           drop the preceding F's after the calculation. Obviously this is 
           why the name is not visible with a hex editor (neither is any 
           other prompt, such as "Registered to:" for that matter). 
           The "Registered to: XXXXXXXX" is stored at file offset 3CF4.  
           Writing 53h over this data in effect writes 20h (or an empty space) 
           over the registrants name.


                                        Enjoy,

                                        ÉÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍ»
                                        º        ô                 º
                                        º  °±²¯  ³HADOWHAWK  ®²±°  º
                                        º        õ                 º
                                        ÈÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍͼ                         
                                                     and
                                                 _        _
                                                  Mephisto