______________________________________________________________________________

                    *** TNC's MAILBOX COMMANDS SUMMARY ***
______________________________________________________________________________


[ALT-X] ------>  To access mailbox routine.

[ALT-F8] ----->  To access memory resident Editor. 

[B] ---------->  To Exit mailbox routine and go back to the terminal mode.

[H] ---------->  To get this file.

[K] ---------->  To Kill a message on the TNC's mailbox. Use: <K message #>.
                 (eg.  K 4).

[R] ---------->  To read a message on the TNC's mailbox. Use: <R messgae #>.
                 (eg.  R 4).
                 To capture a message to disk that you are reading, press
                 F6 after you type the R # command.

[S] ---------->  To Send a message to someone you must type the following:
                 <S callsign,title>.  (eg. S N3DFD,Hello there...). At this
                 point you will be able to type in your message or upload a
                 file from the disk as the message. When finished typing in
                 your message, type a CTRL-Z or /EX on a seperate line to
                 close the file.  If you are uploading the message from the
                 disk you don't need to send the CTRL-Z, the pgm will do it
                 for you.

To have your system automatically connect a user to your TNC's mailbox, set
CMSG parameter to PBBS rather than ON.  Do this from the terminal mode:
Type CMSG PBBS and then press the Enter key. If you do not want this feature
then type CMSG OFF.