TITLE: 1XX SYSTEM BOARD ERRORS.............................1001

  101    POST Error - Interrupt failure.
  102    POST Error - Timer failure.
  102    DIAGS Error - Real time clock 64 byte CMOS RAM TEST
  103    POST Error - Timer interrupt failure.
  103    DIAGS Error - 2KB CMOS RAM TEST
  103    (PS2TAPE    - Insufficient memory for program to load)
  104    POST Error - Protect Mode Failure
  104    DIAGS Error - Real time clock timing test
  105    POST Error - Last 8042 command not accepted.
  106    POST Error - Converting logic test.
  107    POST Error - Hot NMI test.
  108    POST Error - Timer bus test.
  109    POST Error - Low meg CHIP SELECT test
  109    DMA or arbitration error (8550 & 8560 only)
  110    POST Error - Planar PARITY
  111    POST Error - I/O PARITY
  111    DIAGS Error - Test Protect Mode (80286 type protect mode test)
  112    POST Error - Watchdog timeout
  112    DIAGS Error - Test 80386 New and Extended Registers
  113    POST Error - DMA arbitration timeout
  113    DIAGS Error - Test 80386 New Instructions
  114    POST Error - External ROM checksum error
  114    DIAGS Error - Test 80386 32-bit Adressing Modem
  115    DIAGS Error - Test 80386 Protect Mode
  116    DIAGS Error - Test 80386 16/32 bit (mult., div., sub., add)
  118    POST Error - Logged memory error - run Adv Diags (90 & 95)
  120    POST Error - processor self test failed
  121    DIAGS Error - Test Hot reset of processor (via port 90H)
  131    DIAGS Error - Test DMA Compatibility Registers
  132    DIAGS Error - Test DMA Extended Registers
  133    DIAGS Error - Test DMA Verify Logic
  134    DIAGS Error - Test Arbitration Logic
  152    DIAGS Error - Real Time Clock Failure (or CMOS RAM ERROR) -
  152                  invalid error if using V1.0 Reference Diskette.
  160    POST Error - Planar ID not recognized
  161    POST Error - System options not set - (Run SETUP) - battery failure
  162    POST Error - System options not set - (Run SETUP)
  163    POST Error - Time and date not set- (Run SETUP).
  164    POST Error - Memory error - (Run SETUP if memory added or deleted)
  165    POST Error - System options not set - (Run SETUP) - card ID mismatch
  166    POST Error - Card busy error
  167    POST Error - Clock not updating
  169    POST Error - Planar/processor card mismatch (Run SETUP)
  170    POST Error - ASCII setup conflict
  171    DIAGS Error - Failed I/O addressing test
  173    POST Error - CMOS checksum error (Run SETUP)
  174    POST Error - Bad configuration (Run SETUP)
  191    DIAGS Error - Failed 82385 cache test
~~~~~