ÉÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍ»
 º                                                                         º
 º    Above Board Memory Configuration for Lotus 1-2-3 Version 3.0         º
 º                                                                         º
 ÈÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍͼ

 LOTUS 123 VER 3.0

         (This information comes from Lotus 1-2-3 Release 3.0 documentation,
         Appendix, Memory Management.  Information on structuring files for
         minimum memory use and regaining lost memory is also contained in
         this section of Lotus' documentation.)

     MEMORY REQUIREMENTS:
     MINIMUM:      640Kb conventional, 384Kb extended.
     RECOMMENDED:  640Kb conventional, 1Mb extended, and any additional as
     expanded.  Be sure that the extended memory has not been allocated to
     other applications such as disk caches. Check CONFIG.SYS and
     AUTOEXEC.BAT if unsure.

     Since most DOS applications cannot use extended memory but can make use
     of expanded, configure as much expanded memory as needed for other
     applications that use it.

     When configured for both kinds of memory, the 1-2-3 program is stored
     in extended and data in expanded.  When expanded is full, 1-2-3 places
     any additional data in extended.

     For i386CPU-based systems with drivers that emulate expanded memory:
     "If this memory is not already being used, 1-2-3 will automatically use
     this memory as extended memory.  However, 1-2-3 will use only the
     amount of memory that the drivers control.  This amount is usually set
     by a statement in your CONFIG.SYS file."  Check your documentation for
     your driver to change it.

     "NOTE:  1-2-3 works with these drivers only if they support the Virtual
     Control Program Interface, (VCPI).  Among those that support VCPI are
     Qualitas' 386MAX (TM) version 4.03 or later, QEMM - Quarterdeck
     Expanded Memory Manager (TM) version 4.2 or later, and CEMM - Compaq
     Expanded Memory Manager (TM)."


ÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍ
End of file                 Intel FaxBack # 1058          August 13,1992