JCSCROLL (tm) Version 3.00 - (c) 1992 by Jeffrey Chasen This is version 3.00 All known problems have been fixed. New Feature: ------------ Support for ALT-Key combination activation has been added. Just pass a command-line parameter such as JCSCROLL /K={ALT}Y to have ALT-Y be the hot-key. Also, I have added full DOS 5.0 type syntax. For example, JCSCROLL /? will give you a command summary. And /L is the same as -L. NOTE: Mono mode is supported, but I do not support dynamically switching from MONO to color modes. Whatever state your computer was in when JCScroll was installed is what it uses. So if you are in a color mode when you install JCScroll and then switch to a MONO mode JCScroll will work on the color monitor. JCScroll is a tsr that will enable the DOS user to scroll up on the screen in order to view text that has scrolled by. For example, you issue a DIR command and get a list that scrolls by too fast for you to see. Well, with JCScroll just activate the tsr by hitting the left and right shift keys, and you will be able to scroll up and see the text that scrolled by. You may use the arrow keys, PgUp, PgDn, Home and End keys to scroll. This version of JCScroll supports EMS. The tsr itself will only take 10k It also supports all text modes (i.e. 80x25, 40x25, 80x40, 80x50). You may also activate JCScroll from within any text application. So, for example if you are in you word processor and you would like to see what was on the screen before you entered your program, just activate JCScroll and scroll up. The number of lines that JCScroll will store is configurable with a command line option. JCscroll will work on any IBM compatible. JCscroll is shareware. A registration fee of $10 is appreciated. Send check or money order to : Jeffrey Chasen 20 Sunnyside Ave, Suite 143 Mill Valley, CA 94941 (415) 389-8770 Directions: ----------- Usage: JCSCROLL /L= [/N] [/K=] Usage: JCSCROLL /U /N Do not use EMS even if it is available /K is one of the following: SHIFT - both shift keys (Default) {alt}A-Z - Any ALT+key combination Example: JCSCROLL /L=100 /N /K={alt}Y JCScroll will activate with a 100 line buffer when ALT-Y is pressed. EMS will not be used even if it is available. Example: JCSCROLL /U JCScroll will be uninstalled from memory. Each screen of 25 lines takes up 4096 bytes. Max. of 150 lines. To activate press + . ESC to exit. Use arrow keys, PgUp, PgDn, Home and End to scroll. Program will not activate if there is nothing to scroll.