INSTALLATION

Copy the OS2WWWxx.ZIP file into a directory named "\PowerWeb" and change your current directory to "\PowerWeb".
Unzip using either pkunzip or unzip as follows:
unzip -x os2www.zip pkunzip -d os2www.zip
Note: It is important to use the command line switches shown above to create the sub-directories below "\PowerWeb".
Running install, according to your IP ADDRESS:
- If you are using a dynamic IP address, (in other words you do not have a permanent Internet connection) then ensure that your HOSTS file in your \mptn\etc or \tcpip\etc directory contains the following line:
  127.0.0.1 localhost
  and then run
  INSTALL -local
  and follow its instructions carefully, and fill in all forms completely.
- If you are using a permanent IP address, then run
  INSTALL
  and follow its instructions carefully, and fill in all forms completely.
- The INSTALL program will tell you which URL page to load into your browser to continue the installation. You cannot continue without having run INSTALL first.
Do not delete the OS2WWWxx.ZIP file after a successful installation, it has been moved to a system directory, in case you need to re-install.

IN CASE OF PROBLEMS

Read these notes on correctly setting up TCP/IP under OS/2 for PowerWeb.

Point your browser here to read the Readme.Txt file, which contains additional information on how to setup PowerWeb Server++.