01 INSTALLATION OF GARNER FILE ANALYST SOFTWARE
   INSTALLATION OF GARNER FILE ANALYST SOFTWARE 
   *   1. You should now be logged to A: prompt and running
   *      this INSTALL program from A: prompt. If not, Press
   *      ESC and start over.
   *
   *   2. DEMO INSTALLATION DISK should now be in drive A.
   *      If not, insert it in drive A now. 
   * 
   *   3. In general, you will be asked only a few questions,
   *      which will be explained later. The system is
   *      installed in 2 passes. First, the software is copied
   *      to your hard drive. In the second pass, this INSTALL
   *      program will read your hard drive to double check
   *      that the system was installed correctly. If you have
   *      any error conditions, simply terminate this install
   *      run and start all over. If you still have errors see
   *      your manual for details.
   * 
   (Press any key to continue)
02 PATH SCREEN INFORMATION
   PATH SCREEN INFORMATION
   *  At the prompt, key in the path where you want to install
   *  the system. Make sure you include the drive letter in
   *  the path. This INSTALL program will automatically create
   *  the directory "PCU11\" in that path. Do not key PCU11 as 
   *  part of the path. To accept c:\ as the path, press ENTER
   *  at the prompt. 
   *           Sample valid paths are:  
   *               1.   c:\
   *               2.   c:\appl\
   *               3.   c:\tools\
   *               4.   c:\myfiles\util\
   *               5.   d:\appl\util\
 (Press any key to continue)
03 AUTOEXEC.BAT SCREEN INFORMATION 
   AUTOEXEC.BAT SCREEN INFORMATION 
   *    System must reside in pcu11. If you DO NOT add pcu11
   *  to the autoexec.bat, you must log to pcu11 every time
   *  you use the system. 
   *
   *     If you install it, for example, at c:\appl\pcu11 and
   *  you DO add it to the autoexec.bat PATH entry, you can
   *  then run from any location at any time. For example:
   *  
   *        Before: PATH c:\wp51\;c:\ws
   *        After:  PATH c:\appl\pcu11;c:\wp51;c:\ws
   *
   *     If you are still not sure, then add the path to the
   *  autoexec.bat file, since this should not affect the
   *  running of any other software.
   (Press any key to continue)
99 END OF MESSAGE FILE














