========================================================================
 BBS: ORION
Date: 06-04-94 20:13                   Number: 414
From: AUGUST ABOLINS                   Status: Public
  To: ALL                                Rcvd: -NO-
Subj: A BRE SOLUTION..                   Conf: RBBS Subboard
------------------------------------------------------------------------
If there is any RBBS sysop currently running Barren Realms Elite (BRE)
door and would like to get rid of the "Do you want ANSI? Y/n" prompt,
here is a fine solution I found.

1) Convert DORINFO1.DEF to DOOR.SYS.  I decided to use Eddie Rowe's
   Rdoorsys.exe

2) use the following SETUP.SR file:

d:\rbbs\DOOR.SYS
10   <- Line # of Username or First name
0   <- Line # of Last name (0 if previous line was entire name)
20   <- Line # of IBM characters (1 or Y or G = yes)
20  <- Line # of ANSI support (1 or Y or G or C = yes)
21   <- Line # of number of lines on the screen
2   <- Line # of baud rate
1   <- Line # of COM port
19   <- Line # of time left, in minutes
0   <- Line # of Real Name, or 0 if the same as above
Enter 0 for any value not supported.



That's it!

                                             _     _     / __
                                        A.  /-\|_||_,|_| / /   Abolins
                                                    a.abolins@ieee.org

... ..................................................................
--- Via Silver Xpress V4.00 CA-2780
 * Origin: JobNET Remote Node II [514-956-6366] (1:167/365.1)