FPServer: THE Fast Novell NetWare Print Server
                                Version 3.4
                  Quick Start Instructions (QWKSTART.TXT)
            ==================================================
                            Richard L. Hartman
                 Novell Registered Professional Developer
             5205 North Mulvaney Court, Spokane WA 99212-1611
                   509-924-6576 Voice   509-926-4626 Fax
                76350,2275 CompuServe   rlh@iea.com Internet


===========================================================================
QUICK START
===========================================================================

If you wish to get FPServer up and running immediately - without reading
the FPSERVER.TXT file - the following steps will allow you to service a
single print queue on LPT1:

    1) Select a host PC for the test (this can be any PC that is on the
       network and has a directly-connected printer, including a user's
       normal workstation).

    2) Run QRIGHTS.EXE (included with FPServer) to set up the necessary
       rights to the print server object using the following syntax:

           QRIGHTS  printserver  printqueue  <enter>

    3) Start FPServer with a command line parameter which specifies the
       port, file server, print server, and print queue as follows:

           FPSERVER  LPT1QUEUE=fileserver/printserver/printqueue  <enter>


The LPT1QUEUE command must use forward slashes and have no embedded spaces.
All three parameters - the file server name, AND the print server name, AND
the print queue name - must be supplied as shown.  The command is not case
sensitive, so upper and lower case characters may be freely intermixed.

Steps 1 and 2 are setup steps which need not be repeated.  You may restart
FPServer as many times as you wish with the command in step 3.

Please read the FPSERVER.TXT file for complete information on FPServer.
Thank you for your support!