01
0100
0010
R & R
0020
R & I
0030
Adjust
0040
Diagnose the problemo
0050
MIG Weld
0060
Repair
0070
Replace
0080
Repair air tube into converter & MIG weld
0090
Cut muffler off welded system & replace
Replace converter back exhaust system
0110
Replace extension pipe
0120
Re-install
0130
Check antifreeze for protection level
0140
Remove & replace water pump.
0150
Press
0160
Repair sheet metal @ upper shock mounting.
0170
Remove & replace
0180
Remove & install
0190
NOTE:
0200
MISC
Remove engine strip of parts & components.
Transfer parts onto factory rebuilt long block
Install engine assembly in car & test.
Install engine assembly into truck & test.
Install engine assembly into van & test.
Transfer parts onto good used engine.
Overhaul complete long block & assemble engine
Replace front trans. seal while engine is out.
Rebuild
R & I valve cover - adjust valves
R & I front cover-replace timing
R & I cylinder head - replace gasket.
Recondition engine using listed parts & reseal
Strip used engine transfer parts from old.
Pressure test cooling system /check for leaks.
Refill & bleed cooling system.
Strip down head for resurfacing.
Overhaul short block with parts listed above.
0300
Adjust rear brakes.
Bleed hydralic brake system - (includes fluid)
Clean & adjust rear drum brakes.
Install new front disc brake pads.
Install new rear disc brake pads.
Install new front disc brake pads & rotors.
R & I front calipers & pads - replace rotors.
Repack non-drive wheel bearings.
Remove & install pressed hub assemblies.
Remove & install 4x4 hubs & repack bearings.
Remove & replace both front disc calipers.
Remove & replace both rear disc calipers.
Remove & replace both rear wheel cylinders.
Remove & replace rear drum brake shoes.
Replace rear axle brake lines to cylinders.
Rebuild both rear wheel cylinders.
Lube & adjust emergency brake system.
0400
Grind & prepare surface for welding
Install new
Cut out rusted section of
MIG weld repair section into place.
Remove & replace both front strut assemblies.
Remove & Replace both rear strut assemblies.
R & I both front struts - replace cartridges.
Straighten
Remove & replace inner socket
Remove & replace hood supports.
R & R steering rack w/ remanufactured assembly
Flush power steering pump & hoses & lines.
R & I driveshaft - replace rear universal.
Change transmission fluid / filter / gasket.
R & I trans.-Replace clutch/p.plate/r.bearing.
R & I transaxle-Replace clutch/p.plate/bearing
R & I flywheel for resurfacing.
Replace transmission with good used assembly.
Remove & replace transmission with rebuilt
0500
R & R all listed tune-up parts & set timing.
Remove & replace in-line fuel filter.
Scope analysis of ignition system.
Adjust carburetor & AIM retest.
Replace plugs/set timing/adjust idle & check
Run vehicle to AIM station for testing.
Fine tune & adjust engine after installation.
Remove carburetor - rebuild with new float.
Replace ignition cable set.
Remove spark plugs/sandblast clean & reinstall
Set ignition timing.
Replace distributor cap/rotor & ignition wires
Test charging system & load test battery.
Test fuel injection/pump system.
Diagnostic check of engine system.
Compression test cylinders.
Replace distributor cap & rotor.
Diagnose no-start condition.