Microsoft..............Windows for Workgroups

  WINDOWS FOR WORKGROUPS INSTALLATION NOTES:
  FOR THE INTEL EtherExpress(tm) 16 FAMILY OF NETWORK ADAPTERS
  ============================================================

  This document applies to the EtherExpress(tm) 16, 16TP, 16C, MCA, 
  and MCA/TP.  It contains notes for installing the NDIS driver 
  using the Windows for Workgroups installation program.

  INTRODUCTION:
  -------------
  The setup and configuration of the the EtherExpress card is
  integrated into the Windows for Workgroups setup program.  If an
  EtherExpress card is installed in the computer when you run Setup, it
  will detect the card and display the following message:

   WINDOWS SETUP
   Windows Setup has detected the Intel EtherExpress 16 or 16TP network
   adapter in your computer.  Do you want to install the driver for this
   adapter now? YES  NO

  The Setup program creates a Protcol.ini file it which uses to define
  configuration for the EtherExpress card.  Keywords and values in
  the Protocol.ini file are read by the driver and written to the 
  EtherExpress card.

  NOTE: If you run Softset and set the board for specific values, you
        MUST choose the same values in the Setup program.

  The Windows for Workgroups Setup program does not read the
  EtherExpress EPROM for preassigned values.  However, it does scan the
  computer for conflicts.  It will set the Keyword values in the
  Protocol.ini to their defaults unless it finds a conflict or if you
  manually select a value.  It there is a conflict with the default
  value it will continue until it finds the first unused value.

  For example, if the EtherExpress card is set to IRQ5 before you run
  the Windows for Workgroups Setup, and IRQ3 is unused, it will set the
  IRQ to 3 unless you tell it differently.  This is may only be a
  problem if the EtherExpress card was being used with another network
  OS before the Windows installation.

  Windows for Workgroups configures these options on the EtherExpress
  card.

    IRQ:          Default is 3
    IOCHRDY:      Default is Late
    IOADDRESS:    Default is 300
    TRANSCEIVER:  Default is thin net (BNC/COAX)


  Example PROTOCOL.INI file for the EtherExpress card:
  ----------------------------------------------------
  [network.setup]
  version=0x3100
  netcard=ms$ee16,1,MS$EE16
  transport=ms$netbeui,MS$NETBEUI
  lana0=ms$ee16,1,ms$netbeui

  [protman]
  DriverName=PROTMAN$
  PRIORITY=MS$NETBEUI

  [MS$EE16]
  DriverName=EXP16$
  IOADDRESS=0x300
  IRQ=5
  IOCHRDY=Late
  TRANSCEIVER=Thin Net (BNC/COAX)

  [MS$NETBEUI]
  DriverName=netbeui$
  SESSIONS=5
  NCBS=10
  BINDINGS=MS$EE16
  LANABASE=0