 Messages entered into Fortress' message bases may be up to 9999 characters
long and may be uploaded at a full 300/1200/2400 baud.  To enter a message,
just press "E" at any room prompt, then enter your message.  When you have
typed in your entire message (you do not need to press [RETURN] after each
line), press the [RETURN] key twice in succession.  At the next prompt,
press "S" to save the message for local reading or, if you have net privileges
and the room you are in is a net room, press "N" to save the message so that
users on other nodes that share the room may also read your message.  Another
way to enter a net message is with the following command:
 
 .E(nter) N(et-message)
 
 Enter the .EN at any room prompt and then proceed to enter and save your
message as usual.  You may save the message with either "S" or "N" in this
case.  Either way, the message will be marked as a net message.

 If you've prepared your message offline and want to upload
it "error-free" using XMODEM, this is supported by the following command:
 
 .E(nter) X(modem) M(essage)
  
 For a complete list of .E(nter) options, type:
 .E(nter) ?(help)
 
%DOHELP                          --------------Go to Main Help Menu
%MSGS                          ----------Go to Messages Help Menu
