{Learn ! " "}
{Enter}
w1{DESQ}{Enter}
{DELAY 2}
w2{DESQ}{Enter}
{DELAY 4}
w3{DESQ}{Enter}
{DELAY 6}
w4
{Finish}



This is the Desqview Script used to start up four nodes automatically
in Desqview...  I normally only start the fourth node when it is needed
for local use or when I am using a fourth active node on Com4.  This
can be done manually, or you can do it automatically by either using
Desqview's AutoLearn capability to make a new script, or by modifying
the script above as needed.



The following script does the same thing but starts Desqview up in
50 line mode on a VGA card or similiar...

{Learn ! " "}
rv3{Enter}
{Enter}
w1{DESQ}{Enter}
{DELAY 2}
w2{DESQ}{Enter}
{DELAY 4}
w3{DESQ}{Enter}
{DELAY 6}
w4
{Finish}