The following screens will help you set up The Printing Press
for your disk drive and graphic card configuration. It will
include a few questions as well as some explanation.

If you would like more information about setting up The Printing 
Press, consult the hardware setup section in the on-line
instructions.
}
Type the drive (A, B, C, or D) you'll be using for your data
disk- the disk you use to store your designs or supplementary
art disks such as Graphic Library II.
}
1  - No Compatible Graphics Card 

2  - Color Graphics Card  or Medium Resolution (640 X 200) Monochrome
        Compatible graphics cards include:
        IBM CGA       IBM EGA     Hercules Color.

     Computers with this type of card built in include:
        Tandy 1000    Compaq      AT&T 6300     Leading Edge Model D

3 -  Hercules Monochrome & Compatible cards
}
Now that you have configured for your disk drive and
graphics card, YOU MUST CONFIGURE THE PRINTING PRESS
FOR YOUR PRINTER. To do this:

1. Choose "Hardware Setup" from The Printing Press
   Main Menu.
2. Choose "Select Printer".
3. Choose the printer selection model most appropriate
   for your model printer. 
4. Make sure your printer is on, on line, and connected
   properly, then choose "Test Printer".
}
The following are possible results from the printer test:

1.  If the printer locks up or prints gibberish consult
    the Printing Problems section in the online instructions.
2.  If there are skips between lines try the "CR ONLY"
    option, then retry this printer test.
3.  If it is printing on the same line over and over again
    choose the "CR with LF" option and retry this printer
    test.
4.  If the message "I'm having trouble running the printer driver!"
    appears at the bottom of the screen, try selecting a printer.
5.  If the printer prints a Christmas tree then you are done
    setting up and should choose the "Quit" option.
}