Date:  November 11, 1986 
Number:  161 
 
Title:

 
 The Memory Enable Jumper block, figure 3-9 page 3-13, was 
incorrectly pictured in the NetWare Installation Supplement for 
3Com EtherLink and EtherLink Plus manual (all revisions). 
 
    
 3Com Corporation has introduced a new version of the EtherLink 
Plus board for use in file servers.  The new version is labelled 
EtherLink Plus 2012.  If you have this version refer to the 
following additions to locate the components, select the 
transceiver type, and make the configuration settings on your 
EtherLink Plus version 2012 boards. 
 
 If you have version 1194 boards, follow the instructions in the 
supplement for EtherLink Plus boards.  (There are instructions 
for installing an EtherLink Plus board in both the NetWare 
Installation Supplement for 3Com EtherLink and EtherLink Plus and 
the NetWare Installation Supplement for MICOM-Interlan. 
 
 Shunt plug is mounted on the bottom two rows of pins for the 
default BNC setting.  To select the board's DIX connector (for 
connecting the board to an external transceiver installed on 
thick Ethernet cable), pry the shunt plug up with an IC puller, a 
screwdriver, or some other appropriate tool.  Carefully remove 
the shunt plug and remount it on the top two rows of pins to 
select the DIX connector.