Date:  August 24, 1987
Number:  194

Title:  NETWARE CO-EXISTENCE WITH 3174 CONTROLLER AND TOKEN     
        RING ATTACHMENT

If a 3174 cluster controller with a Token Ring attachment is to be used on
the same Token Ring network with NetWare the following steps must be
taken:

1.   Boot the desired version of IBM PC-DOS on the personal computers.

2.   Execute the "Tokreui" command with the desired parameters, such as
     the node address pre-defined at the host.  (With Personal System/2
     computers the procedure is different.)

3.   Load "Netbeui" with the correct number of service access points
     desired.  This is explained in the Token Ring Netbios manual.


4.   Load the IBM 3270 emulation software as instructed.

5.   Link the NetWare workstation shell for the IBM Token Ring.  The
     "ANET3.OBJ" should be the one that uses software interrupt 7B
     instead of 7A.  This 7B shell is available through your dealer or upon
     request from LANSWER.  If you are using an IBM Personal System/2
     with PC-DOS 3.3 or using PC-DOS 3.3 with an earlier personal
     computer, the "DOS 3.3" shell object must be used.  The version
     number for this shell is 2.01-2.  The size is 63199 bytes and it is
     dated 6-15-87.

     The Token Ring shell object "shelldrv.obj" should be dated 8-12-87 and
     have a size of 4227 bytes.  This shell has been corrected so that if an
     administrated address is defined with "Tokreui" it will be correctly
     recognized by the NetWare file server.  See page 4-7 of your
     Token-Ring Network PC Adapter Guide to Operations for defining
     addresses.

6.   Load the NetWare shell to attach to the file server.

The new Token Ring shelldriver object is available on NetWire.