LOGit Configuration
                         and Registration Utility
                                     
                            Version 2.1 3-19-93
                     (c) 1992, 1993 DYNAMOUS Software.
                           All Rights Reserved.
                              47 Kristin Dr.
                            Rochester, NY 14624


If you have registered LOGit, you will also receive LOGITCFG.  Use LOGITCFG
to enter your name, serial number and code key(1) that you received from
DYNAMOUS Software.  You will also be able to change the default options and
use the 'registered options' not available in the shareware version.

If you received your registered version from a distribution diskette, copy
all the files from the distribution disk to the directory on your hard disk
where you keep your DOS utilities.  For more information concerning copying
files, refer to your DOS manual.

If you downloaded your registered version from the bulletin board, unzip
the files contained in the archive to the directory on your hard disk where
you keep your DOS utilities.  For more information concerning unzipping,
refer to your PKWARE manual.

If LOGit and the configuration program are in your PATH you can execute the
configuration from any directory.  If it is not in your PATH you must
change to the directory on your hard disk where you keep LOGit and the
configuration program.  For more information concerning your PATH, refer to
your DOS manual.

At the DOS prompt type:

c:\utility>LOGITCFG

A colorful and easy to use menu will appear.  There are seven fields you
can change to configure LOGit suit your needs.
The general features of the configuration program are:

þ The top of the screen contains the title, LOGit Configuration.

þ The bottom of the screen contains a one line help message about the
  current field you are on.

þ The F keys to save your changes and to exit the configuration
  program are also shown at the bottom of the screen.

There are seven input fields on the screen:

þ Field one should contain the exact name that you used to register the
  program with DYNAMOUS Software.

þ Field two should contain the serial number you received from DYNAMOUS
  Software.

þ Field three should contain the code key1  you received from DYNAMOUS
  Software.

þ Field four can contain your default prompt message rather than the
  default "LOGit was executed at:" which is standard.  Use this option to
  change the default message you in your log files.

þ Field five can contain the full path and name of the default log file
  you would prefer to create rather that the default LOGIT.LOG in the
  current directory.

þ Field six can be toggled between APPEND and OVERWRITE.  Append will add
  a new entry to the log file each time you execute LOGit.  Overwrite will
  delete any previous log file and create a new log file with the last
  time LOGit was executed.

þ Field seven allows you to set the maximum number of lines to keep in a
  log file when using the APPEND mode.  The range is between 0 and 99
  lines.  If you enter a 0, then no limit will be maintained for the log
  file.

The are many advantages of setting or changing the defaults for LOGit.
This will allow you to use it  in your batch files without supplying any
command line options.  You may still override the default option by using
any of the command line options.

_______________________________
1 Registration Key System (c) 1992 Brian Pirie, used by permission.