============================================================================== MAXTOR MODEL LXT-200A IDE DRIVE ============================================================================== Interface: AT RLL 1,7 Encoding Capacity, Unformatted Capacity, Formatted AT Compatible Per Drive (Mbytes) : 234.00 Per Drive (Mbytes) : 201.00 Per Surface (Mbytes) : 33.40 Per Surface (Mbytes) : 29.60 Per Sector (Bytes) : 512 Parameters Performance Specifications Cylinders : Physical=1320 Transfer rate, Mbits/sec : 10 : Logical=1314 Access Time (Average) : 15msec : Sectors/Track(6 Zones) Access Time (Track-To-Track): 3msec : Zone 1=33 Access Time (Maximum) : 30msec : Zone 3=53 Data Heads : 7 Pre-Comp : NONE MTBF: 150,000 Hous (POH) Dimensions(Inches): 1.625" x 4.0" x 5.750" Power Requirements: +12VDC +\- 5%. 0.6A Typical, 2.5A Maximum + 5VDC +\- 5%. 1.7A Typical, .75A Maximum ============================================================================== LXT-xxxA PCB Layout ÚÄÄÄÄÂÄÄÄÄÄÄÄÄÄ¿ ÚÄÄ¿ ÚÄÄÄÄÄÄÄÄÄÄ¿ ÚÄÄÄ¿ ÚÄÄÄÄÄÄÄÄÄ¿ ÚÄ¿ ÚÄÄÄÄÄÄÄÄÄÄ¿ ³ ³ ÀÄÙ ÀÄÄÙ ÀÄÄÙ ÀÄÄÄÄÙ ÀÄÄÙ ÀÄÄÙ ³ ³ J3 ³ ÉÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍ» ³ ³ ³ J6 º 9 7 5 3 1 º ³ ÀÄÄÄÂÙ ÚÄÄÄÄÄ¿ º ÚÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄ¿ º ÚÄÂÄÅ ÚÄÄÄÁ¿ ³:::|:³<ÄÄÄÄÄÄÄĶ ³ * * * Û * ³ º ³ ÃÄÅ ³ à ÀÄÄÄÄÄÙ º ³ * * * Û * ³ º J5 ³ ÃÄÅ ³ à º ÀÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÙ º ³ ÃÄÅ ³ à º 10 8 6 4 2 º ÀÄÁÄÅ ³ à ÈÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍͼ ÚÄÂÄÅ ³ à ³ ÃÄÅ ³ J1 à ³ ÃÄÅ ³ à J2 ³ ÃÄÅ ³ à ³ ÃÄÅ ³ à ³ ÃÄÅ ³ à ³ ÃÄÅ ³ à ÀÄÁÄÅ ³ à ÚÄÂÄÅ ÀÄÄÄÂÙ J4 ³ ÃÄÅ ³ ÚÄ¿ To attach an external LED, use pins 9-10ÄÄÄÄÄÄÄ> ÀÄÁÄÅ ÀÄÄÄÄÄÄÙ ³ ÚÄÄÙ ÚÄÄÄÄÄÄÄÄÙ ÀÄÄ¿ ÀÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÙ LXT-A Jumper Designations ³1-2³3-4³5-6³7-8³9-10³ ÚÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÅÄÄÄÅÄÄÄÅÄÄÄÅÄÄÄÅÄÄÄÄ´ ³ Master/Slave ³ ³ ³ ³ ³ ³ ³ Only drive in single drive sys ³ R ³ ³ ³ ³ ³ ³ Master in dual drive system ³ R ³ ³ ³ ³ ³ ³ Slave in dual drive system ³ J ³ ³ ³ ³ ³ ÃÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÅÄÄÄÅÄÄÄÅÄÄÄÅÄÄÄÅÄÄÄÄ´ ³ Drive Active (System LED) ³ ³ J ³ ³ ³ ³ ÃÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÅÄÄÄÅÄÄÄÅÄÄÄÅÄÄÄÅÄÄÄÄ´ ³ Slave Present ³ ³ ³ ³ ³ ³ ³ One drive in single drive sys ³ ³ ³ R ³ ³ ³ ³ Master in dual drive system ³ ³ ³ R ³ ³ ³ ³ Slave in dual drive system ³ ³ ³ O ³ ³ ³ ÃÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÅÄÄÄÅÄÄÄÅÄÄÄÅÄÄÄÅÄÄÄÄ´ ³ Two Drive System ³ ³ ³ ³ ³ ³ ³ One drive in single drive sys ³ ³ ³ ³ R ³ ³ ³ Master in dual drive sys ³ ³ ³ ³ J ³ ³ ³ Slave in dual drive sys ³ ³ ³ ³ R ³ ³ ÃÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÅÄÄÄÅÄÄÄÅÄÄÄÅÄÄÄÅÄÄÄÄ´ ³ Sync Spindle Pulse Source ³ ³ ³ ³ ³ ³ ³ If receiving pulse ³ ³ ³ ³ ³ R ³ ³ If transmitting pulse* ³ ³ ³ ³ ³ J ³ ÀÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÁÄÄÄÁÄÄÄÁÄÄÄÁÄÄÄÁÄÄÄÄÙ J=Jumpered R=Removed O=Optional *=This jumper may only be used only on one drive in an array CMOS Configuration: Cyls Hds Write Landing Sec/Trk PreComp Zone 200.5MB Capacity --------------------------------- (191 Million Bytes) 816 15 0 0 32 NOTE: This drive has been factory Low Level Formatted. LXT-200A is a trademark of Maxtor Corporation. AT is a registered trademark of IBM Corporation. Specifications subject to change without notice. Copyright 1992 Maxtor Corporation. ==============================================================================