-----------------------------------------------------------------
      STACKER NOTE                                         STACKER NOTE
                  TOO FRAGMENTED TO UPDATE A STACKER DRIVE
                          (Applies to Stacker 4.0)
      STAC FAX  4008 (03-15-1994)
      -----------------------------------------------------------------
                                      
                                      
      BACKGROUND
      
      When you upgrade to Stacker 4.0 from a previous version, you may
      receive the message "This drive is too fragmented.  Use the
      Stacker Optimizer to optimize your drive and re-run SETUP from
      the Stacker installation disk(s)." However, if the Setup process
      re-introduces fragmentation, the update  may fail again.
      
      SOLUTION
      
      Do a quick Optimize, and then manually update the Stacker drive.
      
       1.  Run the quick Optimize. At the DOS prompt type:
           SDEFRAG /Q <enter>
           Even if your drive reports 0% fragmentation, continue with
           the optimization.
       2.  After the optimization is complete, from the DOS prompt type:
           STACKER <enter>
       3.  Locate the line concerning the drive that failed to update.
           For example:
           Drive C was drive C at boot time [D:\STACVOL.DSK = 115.3MB]
           Note the drive letter in brackets, in this case D.
       4.  From the DOS prompt
           type:
           HCONVERT DRIVE:\STACVOL.DSK /C
           Where  drive: is the drive letter you noted above.
       5.  After the drive is updated, you should run the Optimizer to
           take full advantage of Stacker 4.0's improved compression.
           From the Stacker Toolbox in either DOS or Windows, choose
           Optimize, and select Full-MaxSpace.
      -----------------------------------------------------------------
      Copyright 1994 Stac Electronics