-----------------------------------------------------------------
      STACKER NOTE                                         STACKER NOTE
                    AUTOMOUNTING REMOVEABLE STACKER DISKS
                          (Applies to Stacker 4.0)
      STAC FAX  4511 (03-24-1994)
      -----------------------------------------------------------------
                                      
      BACKGROUND
      
      If you compress a removeable disk, it should automount when you
      insert the disk into its drive. If it does not, you may modify
      the parameters in the STACKER.INI file to enable automounting.
      
      SOLUTION
      
       1.  From the DOS prompt, type: ED /I <enter>. This will bring up
           the STACKER.INI file in an editor.
       2.  Add the following lines to the end of the STACKER.INI file:
           /AUTO
           /RP=n
           Where n is the number of removeable drives you have
           compressed.
       3.  Then add one line with the following syntax for each
           removeable drive you have compressed:
           x:\STACVOL.DSK,RP
           Where x is the drive letter of the removeable drive.
       4.  Save the file and restart your system to enable
           automounting.
           
      -----------------------------------------------------------------
      Copyright 1994 Stac Electronics