GammaCAD PRO 2.00  (08 AUG 95)

This document contains installation instructions.

INSTALLING GammaCAD PRO
-----------------------
You must have approximately 3M of free disk space to install
the program.

To install this program select "Run" from the "File" menu of the
Program Manager.  Type the following in the "Command Line" box.

   a:\setup

Replace the path "a:\" with the path which contains the GammaCAD
files. For example, use "b:\setup" if they are on a disk in the b:
drive.  Press Enter or click on the "OK" button to execute the 
command after you have entered it.

The setup program will display a menu which allows you to enter
the source and destination directories for the install. The source
defaults to the directory from which you ran SETUP.  The destina-
tion defaults to "c:\gcadp". These defaults are usually correct.
To use them press Enter or click on "OK".  If you wish to install
the software to a different directory, press TAB to highlight the
destination field.  Type in the path in which you wish to place
the software and press Enter.

Click on the "Cancel" button to leave the install without install-
ing the software.  Clicking on the "View Document File" button 
will bring up the Notepad program and allow you to view this file.
Select "Exit" from the "File" menu to return to the install.

After the GammaCAD installation menu is completed, the install will
copy the files from the source drive to the destination directory.
If you are installing GammaCAD to the same directory as a previous
version, the install will prompt you before copying a file from the
source drive which already exists in the destination directory.  
Press the Y key to answer "yes" and overwrite the file from the 
previous version.  

After all the files have been copied, the install will create a 
Program Manager group and add the program icons to that group if
you request it to do so.  The group will be named "GammaCAD PRO."