ÉÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍ» º º º Configuring Communications Software: E-P º º º ÈÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍͼ CROSSTALK COMMUNICATOR Crosstalk Communicator comes free with every Intel 14.4EX modem. It offers 13 different terminal emulations and 8 file transfer protocols including ZMODEM. The Intel version of Crosstalk Communicator contains set up selections for all Intel modems. The off-the-shelf version from DCA must be configured specially for your modem. The table shows the settings that are different from modem to modem. The list shows settings that are the same for all Intel modems. ÚÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄ¿ ³ Table of Unique Intel Modem Settings ³ ÍÍÍÍÍÍÍÍÍÍÍÏÍÍÑÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÑÍÍÍÍÍÍÑÍÍÏÍÍÑÍÍÍÍÍÍÍÍ ³ ³Max ³Lock ³Modem Modem ³ Modem Init ³Speed ³Speed³Flow ÄÄÄÄÄÄÄÄÄÄÄÄÄÄÅÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÅÄÄÄÄÄÄÅÄÄÄÄÄÅÄÄÄÄÄÄÄÄ 2400B ³ ³ ³ ³ 2400EX ³ ATE0Q0V1X4^M ³ 2400³ off ³ off 2400B Modem 2 ³ ³ ³ ³ ÄÄÄÄÄÄÄÄÄÄÄÄÄÄÅÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÅÄÄÄÄÄÄÅÄÄÄÄÄÅÄÄÄÄÄÄÄÄ 2400B MNP ³ ³ ³ ³ 2400EX MNP ³ ATE0Q0X4\J0\N3\Q3\V1^M ³ 4800³ on ³ rts/cts SatisFAX. ³ ³ ³ ³ ÄÄÄÄÄÄÄÄÄÄÄÄÄÄÅÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÅÄÄÄÄÄÄÅÄÄÄÄÄÅÄÄÄÄÄÄÄÄ 14.4EX ³ ATE0Q0V1X4\J0\N3\Q3\V1^M ³ 38400³ on ³ rts/cts ÄÄÄÄÄÄÄÄÄÄÄÄÄÄÅÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÅÄÄÄÄÄÄÅÄÄÄÄÄÅÄÄÄÄÄÄÄÄ 9600EX ³^M~ATE0Q0V1X4\J0\N3\Q3\V1^M³ 38400³ on ³ rts/cts ÍÍÍÍÍÍÍÍÍÍÍÍÍÍÏÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÏÍÍÍÍÍÍÏÍÍÍÍÍÏÍÍÍÍÍÍÍÍ ÚÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄ¿ ³ List of Common Intel Modem Settings ³ ÍÍÍÍÍÍÍÍÍÍÍÏÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÑÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÏÍÍÍÍÍÍÍÍÍÍÍ Dial Prefix: ATDT ³ Connect: CONNECT^M^J Dial Suffix: ^M ³ Connect Speed: CONNECT %^M^J Modem Init: {see table} ³ Connect Rel.: CONNECT %/REL^M^J Answer Setup: ^M~ATS0=1^M ³ No Connect: NO CARRIER^M^J Hang Command: +++~~~ATH^M ³ Line Busy: BUSY^M^J Max Speed: {see table} ³ Command OK: OK^M^J Lock Speed: {see table} ³ Command Error: ERROR^M^J Results Only: off ³ Dial Tone: Modem Flow: {see table} ³ No Dial Tone: NO DIALTONE^M^J Address:{3F8,2F8,3E8,2E8}³ Ring: RING^M^J IRQ: {4, 3, 5, 2} ³ ÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÏÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍ ÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍ February 24, 1992 Intel FaxBACK # 4354 Page 1 ÉÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍ» º º º Configuring Communications Software: E-P º º º ÈÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍ (continued) ÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍͼ LOTUS EXPRESS * Customer report * One user reports that Lotus Express works with an Intel 9600EX when you use this command in the Connection Initialization string: ATV1X1DT@N|{CONNECT}@M MTE/MTEZ All of Intel's modems are defined in MTE and MTEZ's setup, and no extra setup is required. PC ANYWHERE VERSION 3.X This program is compatible with Intel modems. The PC Anywhere file AWMODEMX.CNF contains a list of supported modems. If Intel modems are not in this list, you must download the latest AWMODEMX.CNF file from DMA's bulletin board system. All of Intel's modems are listed in the latest version of this file. DMA's BBS number is (516) 736-1494. PC ANYWHERE VERSION IV This program is compatible with Intel modems. The PC Anywhere IV AWMODEM.CNF file lists all Intel 2400bps modems. If you want to use a 14.4EX or 9600EX and it isn't listed, you must download the latest AWMODEMX.CNF file from DMA's BBS. DMA's BBS is (516) 736-1494. Special notes about SatisFAXtion and PC Anywhere: It is possible to use PC Anywhere IV to set up remote Faxing on a computer with an Intel SatisFAXtion Board. The SatisFAXtion fax and modem MUST be set to answer on the same number of rings. The fax answer portion can be set in the SETUP program under Advanced Setup/Set Up Technical Software Options/Rings to Answer. The rings until answer option on the modem is set in PC Anywhere IV in the "PC Anywhere Hardware Configuration". You must also use "EXIT" and select "Allow incoming calls" option when starting PC Anywhere 4 HOST. Using any other HOST mode option will cause the computer to lock up if a fax comes in. Set the time on the remote PC to your time, or at least note any time difference between that PC and your time. ÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍ February 24, 1992 Intel FaxBACK # 4354 Page 2 ÉÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍ» º º º Configuring Communications Software: E-P º º º ÈÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍ (continued) ÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍͼ Ensure that a fax gets scheduled for 5 or 10 minutes in the future. If this is not done, the fax board won't accept modem calls from that point on. Disconnect from the Host PC using the EXIT, ALLOW INCOMING CALLS option of PC Anywhere 4. This will allow the HOST PC to release the modem and allow it to send the fax. PROCOMM 2.4.2 AND 2.4.4 This program is compatible with Intel modems. Here's how to configure Procomm. NOTE: This version doesn't support CTS/RTS flow control - only XON/XOFF! After entering Procomm, press any key to go directly into terminal mode. þ Press to access the "Line Settings" menu - Select the Port that the modem is using - Select the "Baud" rate for your modem: 9600EX/14.4EX : 38400 All 2400 Baud MNP modems : 4800 All 2400 Baud non-MNP modems: 2400 - Type 24 and press to save these settings þ Press to access the "Setup Menu" - Press 1 then to select "Modem Setup" - Press 1 then to select "Modem Init String" - Type ATZ then - Press 2 then to select "Terminal Options" - Press 3 then to select "Flow Control" - Press until "XON/XOFF" appears then - Press - Press S then to save "Save Setup to Disk" - Press Now configure your modem using the appropriate command. 9600EX/14.4EX : AT&F\G1\Q1 All 2400 Baud MNP modems : AT&C1&D2\G1\J0\\N3\Q0\V1 All 2400 Baud non-MNP modems: AT&C1&D2 That's all there is to it! ÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍ February 24, 1992 Intel FaxBACK # 4354 Page 3 ÉÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍ» º º º Configuring Communications Software: E-P º º º ÈÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍ (continued) ÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍͼ PROCOMM PLUS V1.0, 1.0B This program is compatible with Intel modems. Here's how to configure Procomm Plus. þ Start Procomm Plus then, press any key to go directly to Terminal mode. þ Press to access the "Line Settings" menu. - Select the "Port" on which you installed your modem. - Select the correct "Baud" rate for your modem: 9600EX/14.4EX : 38400 All 2400 Baud MNP modems : 4800 All 2400 Baud non-MNP modems: 2400 - Press to save the setup þ Press to access the "Setup Utility" "Main Menu" - Select "Modem Options" then "General Options" - Change "Initialization Command" to "ATZ^M" - Press twice - Select "Terminal Options" then "General Options" - Set "Software Flow control" and "Hardware Flow Control" for your modem: Modem Hardware Flow Control Software flow Control ----- --------------------- --------------------- non-MNP OFF ON MNP ON OFF 9600EX/14.4EX ON OFF - Press þ Select "Save Setup Options" then þ Press Now configure your modem. You only need to do this once. þ Enter the corrent command for your modem. 9600EX/14.4EX : AT&F&W All 2400 Baud MNP modems : AT&F\N3\J0\Q3\V1&W All 2400 baud non-MNP modems: AT&C1&D2&W All done! NOTE: Before operating in HOST mode, go into the setup menus and make sure AUTO-BAUD DETECT is set to OFF. PROCOMM PLUS V2.0 AND 2.01 This program is compatible with Intel modems. Procomm Plus V2.0 and 2.01 have all of Intel's modems built in to their setup program. Run ÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍ February 24, 1992 Intel FaxBACK # 4354 Page 4 ÉÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍ» º º º Configuring Communications Software: E-P º º º ÈÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍ (continued) ÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍͼ the PCINSTAL.EXE program in the Procomm subdirectory and select the proper Intel modem. NOTE: Before operating in HOST mode, go into the setup menus and make sure AUTO-BAUD DETECT is set to OFF. ÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍ February 24, 1992 Intel FaxBACK # 4354 Page 5