IBM 2.0G 4mm Tape  

In order for Sytos Plus to access this backup device, you
must remove the 'REM' (if it exists) from the following
line in CONFIG.SYS:

           REM DEVICE=[drive:]\[path]\SYFILES\IBG_DATI.SYS

Note that [drive:]\[path] represents the drive and directory
where the Sytos Plus files were installed and should already
be displayed within this statement.

If this DEVICE= statement does not appear in CONFIG.SYS,
you will need to add it.

Note: After changing your CONFIG.SYS file, you will need to
reboot for this change to take effect.

If you receive a "Backup Device Not Responding" message
when adding this device, you will need to check the backup
device settings again after modifying CONFIG.SYS and
rebooting your system to be sure that the device is set up
correctly.  To do so, run Sytos Plus after you reboot and
then choose "Utilities: Backup device setup."  Verify that 
the settings are correct.