This file contains information on how to install Sytos Plus
 OS/2 and DOS device drivers for systems using the 
IBM 4mm DAT Device.  You should have received 
copies of the drivers either on diskette from Sytron or from 
Sytron's BBS.

Refer to the README file on your Sytos Plus Installation 
Diskettes for possible additional about your particular 
backup device.

To install the device drivers, refer to the appropriate steps.

A. Installing the DOS Device Driver

1.  Copy the file IBG_DATI.DRV  into your \SYPLUS\SYFILES 
     subdirectory on the drive where you loaded Sytos Plus.  
2.  Start Sytos Plus.
3.  At the "Utilities: Backup Device Setup" window select 
     "Add New Device."
4.  A list of available drivers appears.  Highlight and select the 
     correct driver for your system. 
5.  When you finish, choose OK or press F2.
6.  Reboot your system if CONFIG.SYS has been modified.

B. Installing the OS/2 Device Driver

1. Copy the following three files into your \SYPLUS\SYFILES 
    subdirectory on the drive where you loaded Sytos Plus.  
	IBG_DATI.DRV
	IBG_DATI.SYS
	IBG_DATI.TXT
2.  Start Sytos Plus.
3.  At the "Utilities: Backup Device Setup" window select 
    "Add New Device."
4.  A list of available drivers appears.  Highlight and select the 
     correct driver for your system. 
5. When you finish, choose OK or press F2.
6. Reboot your system if CONFIG.SYS has been modified.


                  --- END OF README ---