The Basics of Auto-Attaching And Auto-Invoking SQZ!

If, upon starting 1-2-3, you are faced with the SQZ! Status Window every time, 
you have set SQZ! to Auto-Invoke after Auto-Attaching.  This is not necessary.  

By default, SQZ! is up and operating as soon as it is attached Ä there is no 
need to invoke SQZ! unless you wish to change the Status Window settings.

To correct the problem, reset SQZ! to Auto-Attach, but not Auto-Invoke.  For 
information on how to reset your settings within your specific release of 
1-2-3, please refer to the chart below for the corresponding page numbers in 
your manual.

Lotus 1-2-3 Release 2.2 manual   Pages 12 to 13
Lotus 1-2-3 Release 2.3 manual   Page 276
Lotus 1-2-3 Release 3.1x manual  Pages A6-10 to A6-14
SQZ/Outliner manual              Pages 1 and 2

If you have any questions, please contact SQZ! Technical Support.







































SQZ! Application Note        Rev. 6/92           #7108     Page 1 of 1