FYI
Note:  The origin of this information may be internal or external
to Novell.  Novell makes every effort within its means to verify
this information.  However, the information provided in this
document is FOR YOUR INFORMATION only.  Novell makes no explicit
or implied claims as to the validity of this information.)

          TITLE:  Glyphix and DR DOS
   DOCUMENT ID#:  FYI-M-1612
           DATE:  04JAN93
        PRODUCT:  DR DOS
PRODUCT VERSION:  6.0
     SUPERSEDES:  02JAN92

        SYMPTOM:  GX mode does not work with HP LaserJet

  ISSUE/PROBLEM:  
Glyphix has been tested with DR DOS 6.0 and it exhibits the same
symptoms that it did with DR DOS 5.0. The "GX" mode still does
not work with the HP LaserJet. 

If you are using a Hewlett-Packard Series II, IID, or IIIP, you
should be aware of the following restrictions:

GLYPHIX laser font package for WordPerfect 5.1 has three modes of
operation.  You can choose any of the three modes when starting
the application.  Two of the modes are successful with DR DOS. 
The third is not.

       SOLUTION: 
It is recommend that you change to GXL or GXS to start Glyphix. 
These two modes run well under DR DOS.

GXL.EXE
This is the fastest mode, but it requires the most memory.  (use
DR DOS's memory features and this program should have plenty of
room).  It takes 110K of memory and can print 3-120 point sizes. 
It also allows background printing. 

GXS.EXE
The smaller memory version of GXL.EXE.  Allows you to print up to
60 point, and takes approximately 59K of memory.  It to allows
background printing.


The following mode is not compatible with DR DOS.  It will not
print correctly on the HP printers listed above.

GX.EXE
Requires about 26K of memory.  Also requires over 500K of disk
space to create a temp print file.  

If you are using a Hewlett-Packard Deskjet, the Deskjet driver
for Glyphix has no problems.