mach64, 64UST154.ZIP
*****************************

1.0     Introduction
2.0     Installation Notes
3.0     mach64 1.54 Fixed list

*****************************

1.0     Introduction

This product was developed by Panacea Inc. exclusively for use with ATI's 
family of mach64 accelerators. This version of PanaStation has been 
designed to specifically support DOS versions of MicroStation 4.0 and 
5.0.

*****************************

2.0     Installation Notes

1. Ensure that you have a copy of LOAD64.ZIP.  The LOAD64.EXE utility is 
used to install this driver.  LOAD64.ZIP is available on the ATI BBS, ftp 
site (ftp.atitech.ca), and on our CompuServe forum (GO ATITECH).

2. Ensure that you have a copy of PKUNZIP.EXE, v1.10 or later.  PKUNZIP 
is available on most BBS and information services, including the ATI BBS 
and CompuServe.

3. Do NOT attempt to perform the driver installation from within 
MicroStation. Exit MicroStation completely, and perform the following 
operations in DOS.

4. Unzip LOAD64.ZIP and 64UST154.ZIP into the same temporary directory 
on your hard disk, then run the LOAD64.EXE utility.  For example:

MD \ATITEMP
PKUNZIP LOAD64.ZIP \ATITEMP
PKUNZIP 64UST154.ZIP \ATITEMP
CD \ATITEMP
LOAD64.EXE

5. Follow the screen prompts for installing the MicroStation 4.0, 5.0 
drivers.

6. Once the driver has been installed, you can delete the contents of the 
temporary directory (DEL \ATITEMP\*.*) and delete the directory itself 
(RD \ATITEMP).

7. We recommend that you copy the ZIP files (64UST154.ZIP and LOAD64.ZIP) 
to floppy disk, in case you need to install the driver again.

8. For further configuration instructions, please consult the file 
MANUAL.TXT.

*****************************

3.0     mach64 1.54 Fixed list

This driver is primarily designed to support the complete ATI mach64 
product line, it is not intended to correct outstanding issues.