ASCII(American Standard Code for Information Interchage) DRAW  V. 2.0
CopyRight 1995
        By, Neal Goldstein

To Load The Program Type "ASCIIDRW"
Type The File Name In
If The File Doesn't Exist It Will Create It
Else It Will Load The Drawing And Allow Further Work To Be Done To It
Next, Type The File Name For The ANSI File If Saved In ANSI Format

You Can Only Print 75 CHR$ Characters In The UNREGISTERED Version.
        To Register See ORDER.FRM

To Move The Current Ascii Character Use The Arrow Keys

To Change The CHR$ Character, Use The "+" Key For Up
                              And The "-" Key For Down

To Change The Color, Use The "." Key For Up
                     And The "," Key For Down
To Change The Backround Color, Use The ">" Key For Up
                               And The "<" Key For Down

To Draw The Current CHR$ Character Hit Space

To Erase The Character Set The CHR$ To 32 The Color To 0 And The Backround
        To 0. Go Over The Character To Erase And Hit Space.

To End The Drawing Hit "~" 

To Abort The Drawing Hit ESC

To Use The Drawing In Your Program Use These Routines:
 
CLOSE #1                                         'Close Any Open File
OPEN "Name_Of_File_Saved" FOR BINARY AS #1       'Open The File
LOADDRW:                                         'Begin Loop
GET #1, ,CHR                                     'Get The CHR$ Character
IF CHR = 999 THEN GOTO NEXTSTEP:                 'End Of File
GET #1, ,X                                       'Get The X Position
GET #1, ,Y                                       'Get The Y Position
GET #1, ,C1                                      'Get The Color
GET #1, ,C2                                      'Get The Backround Color
COLOR C1, C2                                     'Set The Color
LOCATE X, Y: PRINT CHR$(CHR)                     'Print The Character
GOTO LOADDRW                                     'Get The Next Character

NEXTSTEP:                                        'Your Program Starts Here


To Save The Drawing In ANSI Format For Use In BBSs, Etc...
Then Hit "`"
The File Will Be Name What You Already Defined Its Name To Be. 
To Avoid Confusion The Preferable File Extension Would Be .ANS
The File Cannot Be Reloaded Into ASCII DRAW So Save In ASCII DRAW 
Format Until You Have Created The Finished Project.
All Color 16 And Greater Will Not Blink...
        This Is A Bug That Will Be Worked Out In Verion 2.1
