This is the setup I use with Telix 3.15 for the SpeedModem Combo.

                 Thus far it has worked without a hitch.


ΥΝ΅ Modem and dialing parameter setup ΖΝΝΝΝΝΝΝΝΝΝΝΝΝΝΝΝΝΝΝΝΝΝΝΝΝΝΝΝΝΝΝΝΝΝΝΝΝΝΈ
³                                                                            ³
³ A - Init string ......... ~~~AT&F2*H1%C0&D2X4S10=30S11=60&M&WH^M
³ B - Dialing prefix 1 .... ATDT                                             ³
³ C - Dialing prefix 2 .... ATDT                                             ³
³ D - Dialing prefix 3 .... ATDT                                             ³
³ E - Dialing suffix ...... ^M                                               ³
³ F - Connect string ...... CONNECT                                          ³
³ G - No connect strings .. NO CARRIER             BUSY                      ³
³                           VOICE                  NO DIAL TONE              ³
³ H - Hang-up string ...... ~~~+++~~~ATH ^M                                  ³
³ I - Auto answer string .. ATS0=1^M                                         ³
³ J - Dial cancel string .. ^M                                               ³
³                                                                            ³
³ K - Dial time ........... 45                                               ³
³ L - Redial pause ........ 1
³ M - Auto baud detect .... OFF
³ N - Drop DTR to hangup .. On                                               ³
³                                                                            ³
³                                                                            ³
³ Change which setting?       (Return or Esc to exit)                        ³
ΤΝΝΝΝΝΝΝΝΝΝΝΝΝΝΝΝΝΝΝΝΝΝΝΝΝΝΝΝΝΝΝΝΝΝΝΝΝΝΝΝΝΝΝΝΝΝΝΝΝΝΝΝΝΝΝΝΝΝΝΝΝΝΝΝΝΝΝΝΝΝΝΝΝΝΝΝΎ


********ALSO MAKE SHURE Z-MODEM IS SET TO 32 BIT CRC**********


 
When ever you logon with /rel (example "CONNECT 9600/rel") Always
Use Y-Modem-g. But if you connect without the /rel 
(example "CONNECT 9600") Use z-modem..
The init string is setup for 9600 without /rel and 2400 and lower
with /rel if the other modem has it.
The modem will connect these ways, 9600,2400/rel,2400,1200/rel,1200
,300

I dont use the CONNECT 9600/rel because its slower then the regular 
CONNECT 9600. I do use CONNECT 2400/rel when available because its
Faster than normal 2400.


The Disk Box II (313)-790-6828