U P D A T E C O N F E R E N C E This command is used to specify the conferences that will be used as defaults for Reading and Scanning messages when the [S]elected command is used. When the Update Conference command is selected a screen appears listing the conferences available to your security level similar to the following: 0) * General Message Area 1) * Games Comments/Info 2) * DOS Commands & Info 3) * Classifieds - Buy & Sell 4) * Technical Information 5) * Printer Technical Info 6) SysOp to SysOp Area 7) * BBS Advertisements 8) * Commercial Software Info 9) * Uploaded File Reviews 10) Comments to the SysOp 11) * NetMail - BBS/BBS Direct -Pause- [#-#], [D]eselect all, [H]elp, [S]elect all, [Q]uit? The above display indicates that you have access to 12 conferences, and that you scan and read from 10 of them (marked with the *) when the [S]elected command is used. You may modify your default conferences by entering the number of the conference to change. Entering a conference number toggles the status from selected (*) to not selected (no *). You may also deselect or select ALL available conferences with the [D]eselect all or [S]elect all commands. [#-#] - You can select a range of conferences to Scan/Read. Type the number of the conference you would like to start and then type the dash ("-") and then type the number of the conference to finish at. This selection will selext all conferences between the two numbers including the conferences selected. ie. [2-5] will select conferences 2, 3, 4 and 5. An "*" will appear next to all the conferences that have been selected. [D]eselect all - This selection will deselect all conferences. You will notice that the "*" next to the selected conferences will disappear. [S]elect all - This selection will select all conferences. You will notice that the "*" will appear next to the conference numbers which are selected.