10 Nov 93 Listed below are the revelant OS/2 config.sys entries for JOE v1.0.8. Please change the directory entries for whatever is correct for your setup. Note that JOE puts its swap file in the directory specified by "joerc" so please leave enough space for editing those large files. Also you need to put the EMX dlls somewhere on your libpath (not shown) or add the directory to the libpath. You'll need to reboot for the changes to take affect. Please note that JOE's termcap is quite different from the GNU one and don't seem to be interchangable. EMX 0.8g was used to port JOE to OS/2. Additionally, JOE also runs under DOS, but not in a DOS window of OS/2. A great thanks to Eberhard Mattes for his wonderful compiler. ========= BEGIN part of OS/2 config.sys ======================= rem joe editor stuff set joetermcap=c:/joerc/termcap set joerc=c:/joerc set joeterm=ansisys rem set number of lines and columns for odd window sizes rem set lines= rem set columns= set baud=38400 ========= END part of OS/2 config.sys ========================= Below is a brief description of what each setting does: joetermcap - specifies the path and name of JOE's termcap file. Do not use the one from GNU. JOE's termcap is special. joerc - specifies which directory has the keyboard mapping file, "joerc". Also, this is the directory where the swap file is kept. joeterm - the terminal type. The one that works is "ansisys" lines - number of lines for odd window sizes columns - number of columns for odd window sizes baud - sets the scrolling speed of the window. 38400 means that the screen is directly connected. -phil (phil@venus.engr.ucdavis.edu)